A great tuning tool, the EGT. Once you have your tune set you will know what tempature is correct for your set-up. Once it goes rich/lean you will know. This could save your motor. also, when changing hit size we know what temp a safe tune runs at, so just another tuning aid/tool. This kit comes complete and is brand new never used, but I did loose the bung for the Pyro probe, though it uses the same weld in style as a WB and we can get easily at any muffler shop. Or you could opt for the clamp on accessory mount from AutoMeter. Can't remember what I paid for it but is complete gauge kit and Pyro probe kit. Hopefully my $75.00 is fair and if that is to high let me know what price you found and we can lower it.

• 2 1/16 Pro Comp Pyrometer Gauge by AutoMeter
• Pyrometer Probe Kit (missing weld in bung)
• Complete Gauge install kit
• Directions for Gauge and Probe

Price: $75.00-Plus Shipping

This first panel is a F-Body Camaro/Firebird Manual tranny in the AshTray style sw panel. Brand new nevr used or wired up. Comes with directions.

Price: $20.00-Plus Shipping

This second panel is for C5 and or Z06 and mounts in the AshTray with screws, or you could use double sided tape. The labels come off and you can use the switches for, Arm, heater, Accessory, or what ever you like. These are heavy duty Marine Grade switches which far in access excede the noraml auto switches used in all panels. You can see this sw panel installed in the Install Pictorial, under electronics, and is a '97 Coupe

Price: $35.00-Plus Shipping

This bad-boy could save your car from a burn down after a back fire dislodges your fuel rails. 3-each per side is 75-90psi burst panels. IHRA mandatory for DP kits with a cast intake. Also the open plenum add volume for tuning the high RPM band. Check their site out for more info on this engineered part. I went another route and it is brand new never used. Cost was is $195.48 list. A great deal at my price. Comes with one gasket of high quality.

Price:  $150.00-Plus Shipping

These are original Z06 covers which have been modded to fit cars with the '97 style fuel system (dual lines, a supply and return). Looks like factory. Pictures can be found on the car through out the web site. That is a shawdo in the picture not dirt.

Price: $75.00   Plus Shipping

When changing from a LS1/LS6 throttle body to a 90mm LS2 style you will need an adapter cable. It is new and never used except for a test proceedure. Cost was $58.90 shipped.

Price: $40.00-Plus shipping

Used but works fine. Off of a 15k mile '02 Z06.

Price: Make Offer

The fuel Pressure Safety Switch is probably the most widely used safety item, and for good reason. should your fuel system fail for any reason, this bad boy willshut the entire N2O kit down. This is the high pressure versionand set for the 58psi cars. This item is used but works fine. Fitting is included for mounting directly on the fuel rail test port.

Price:  $20.00-Shipping Included

Was used once for testing and is otherwise brand new. For/from a C5 Z06.

Price:  Make Offer

Thes are the NX 240 watt bottle heater kits, and teo sites had then for $22x.00 and $24x.00. So my used price on working fine set-ups, minus the wire, is more than half off retail listed price.

The first kit includes:

• NX Heater Element-BLACK
• Off Brand-10lb Bottle Blanket-Black (Freebie)
• Switch and Relay
• NX Install/wiring Directions
• NX Adjustable Electric Transducer (like $80.00 bucks)

The first kit is first come first serve and this one is all black. I had not many heat cycles on this heater pad and is close to new. I chose it because of the lower amp draw compared to others on the market and is a little easier on the charging system. You will need some wire and connectors from the auot parts house. SOLD

Price:    $80.00 Plus Shipping.

The second kit is the same in function. However, the heater element is orange, and the bottle blanket is for a 15lb bottle. The blankets have just been thrown in, so don't ask for a different one please, it's freebie. The orange just means it's an older NX element before going black. You will need some wire and connectors from the auto parts house. SOLD

• NX Heater Element-ORANGE
• Off Brand-15lb Bottle Blanket-Black (Freebie)
• Switch and Relay
• NX-Install/Wiring Directions
• NX-Adjustable Electric Transducer (Like $80.00)

Price:     $75.00  Plus Shipping

This really the only electric bottle opener designed to stay on or off. A regular solenoid could never stay with power applied.I had this installed on my Z)^ when I was running a single 15lb bottle (see picture below). If your going with a 300 shot it may not flow enough, but it flowed ebverythimng I could throw at it. Simple on the dash toggle switch open or closed. This solenoid has just been rebuilt thanks to NOS service dept and never used since. This solenoid can be and is used as a safety shut off also. You will need some wire and connectors from the auto parts store. Last time I looked this kit was selling for about $160.00, IIRC, and the polished SS fittings are worth $50.00 on there own. If you would like steel fittings instead, it will be cheaper.NOS-Heavey Duty Solenoid (SS body is polished) SOLD

• NOS-Instructions/Wiring Diagram
• Switch and Relay
• Stainless Steel Fittings (about $25.00 a piece)

 Price:   $65.00-Plus Shipping     Price: $90.00 With SS Fittings-Plus Shipping

I had a ton of these bottle blankets, OK, nit a ton, but quite a few. However, once everyone saw i was getting rid of them for next to nothing, they grabbed them up. I have one 15lb blue NOS brand blanket left, and it is used but in good shape. A great topper to your bottle heater or NANO kit, keep it cool in the Summer, and warm in the Fall. SOLD

Price: $18.00-Plus Shipping.

Here is a original MSD window switch, the Pill style. It has the 3400rpm and 6400rpm activation pills in it right now. You can buy them for $5 a piece at various outlets if you would like different rpms. The thing about these older sytle switches is they are trouble free and you can always count on them to work. Complete with directions and wiring diagram. SOLD

Price: $40.00   Plus Shipping

I have a bunch of small solenoids good for purge kits. so if you want to save some money and put your own kit together here you go. I will rebuild all of the solenoids prior to selling. just let me know what you are looking for. i also have a few regular sized solenoids which are used as main noids. Prices to be established. SOLD OUT

Misc small solenoids, some are brand new, and some used. The used ones will receive a rebuild prior to selling. NOS, DynoTune, Cold Fusion...

Large Fuel solenoid, new.

Industrial Nitrous solenoid used for bottle opener.

These are standard bottle brackets that come in many different kits from varying companies. Brand new coated for bottle protection, never used. SOLD

Price: $15.00-Plus Shipping